How To: Make an advanced, 8 shot rubber band gun

Make an advanced, 8 shot rubber band gun

How to Make an advanced, 8 shot rubber band gun

In this how-to video, you will learn how to make a rubber band gun. You will need a half inch of plywood, basswood, a dowel, rubber bands, finishing nails, tacks, water bottle, sand paper, spade and drill bits, hammer, a ruler, a cutting knife, and a compass. Cut off the top of the bottle. Measure all the parts into the ply wood and cut them into small sections. Cut out the circles and drill a hole into three circles. Notches should be drilled into the circles, as well as holes. Now cut the dowels so they are 9 inches long. Cut smaller ones as well. Cut small rectangles out as well. Cut out the handle from the basswood. Cut out 2 inches from the dowel. Sand these pieces. Next, place the small dowels into the circles with notches. Assemble the pieces together. Slide the entire water bottle over the circles. Nail the last circle into place for the top. Take a rubber band and wrap it around the dowels inside. Next, load the gun and you are ready to use it.

Be the First to Comment

Share Your Thoughts

  • Hot
  • Latest